This article is about 

-Following the on screen directions for calibration consistently results in "Accuracy 0%  Error Occurred".

-I am unable to set "User Set Depth."


Those errors usually occurs due to an issue relating with the depth sensor, possibly one of the following:

  1. The calibration process was too inaccurate
  2. Cable connecting the control board and the depth sensor may be disconnected
  3. Depth sensor may be broken therefore needs replacement


First, repeat the calibration process. See "Calibrating the depth sensor on the Voyager" for the correct process.


If the issue persists, check the cable connections on the inside of the panel by following case 2 of the attached PDF.


If the issue does not resolve after checking all of the connections on the blue control board, the depth sensor will require replacement. Follow case 3 of the attached PDF.