Teknatool International

Announcements 1

• Voyager Reviews
  Posted by Nichole Harstad, over 1 year ago

  Last Reply by Nichole Harstad over 1 year ago

Feature Requests 9

• DVR Headstock.
  Posted by Ian Summersby, 6 months ago

  Last Reply by Nichole Harstad 6 months ago
• Nova Voyager DVR HMI Enhancements
  Posted by David Persuhn, over 3 years ago

  Last Reply by David Persuhn over 1 year ago
• Nova Voyager to Vulcan Spindle Upgrade
  Posted by Jim O'Keefe, over 1 year ago

  Last Reply by Jim O'Keefe over 1 year ago
• Nova DVR 1644 Firmware Upgrade
  Posted by Mark Altenburg, about 3 years ago

  Last Reply by Nichole Harstad over 1 year ago
• Koenig lathe chuck
  Posted by Larry schiller, over 1 year ago

  Last Reply by Larry schiller over 1 year ago
See all 9 topics

Tips and Tricks 8

• DVR3000 built 2001 approx.
  Posted by Paul Giddins, 9 months ago

  Last Reply by Nichole Harstad 9 months ago
• DVR 3000 MOTOR.
  Posted by Paul Giddins, 9 months ago

  Last Reply by Nichole Harstad 9 months ago
• serial no. on my GVR3000 lathe
  Posted by Paul Giddins, 9 months ago

  Last Reply by Nichole Harstad 9 months ago
• Does this Voyager sound normal?
  Posted by Karl Biewald, over 1 year ago

  Last Reply by Karl Biewald over 1 year ago
• Bolt pattern
  Posted by Kelly Rider, about 2 years ago

  Last Reply by Spencer Herran‏ about 2 years ago
See all 8 topics

Report a problem 14

• Reverse delay time
  Posted by Normand Therrien, 6 months ago

  Last Reply by Nichole Harstad 6 months ago
• Headstock alignment
  Posted by Roger Cook, 7 months ago

  Last Reply by Roger Cook 7 months ago
• loose headstock
  Posted by Bill Eppelstun, almost 2 years ago

  Last Reply by Spencer Herran‏ almost 2 years ago
• Nova Superchuck Key
  Posted by Paul_gibbs, almost 2 years ago

  Last Reply by Paul_gibbs almost 2 years ago
• Change voltage on 2024 DVR lathe ? Not the XP.
  Posted by Jo Searle, about 2 years ago

  Last Reply by Spencer Herran‏ about 2 years ago
See all 14 topics