This FAQ article shows how to enable the Galaxi DVR lathe to run on 220V power supplies.


The internal circuits on the Galaxi lathe is able to take in either 110V or 220V without changing it's hardware but the plug on the power cable has to be replaced

with a model which is rated at 15A instead of 10A which is the default. 


Note: 

In countries such as the USA, plug geometry will be different between 10A and 15A rated plugs therefore be careful when purchasing the replacement plugs.

(This article uses US plugs)


*We do not supply these 15A replacement plugs therefore each customer will have to purchase it by themselves*