DVR GALAXI 1644

How to enter service mode on the Galaxi DVR 1644 lathe
The attached FAQ document will show how to get into service mode on the Galaxi DVR 1644 lathe.  Service mode will allow access to more parameters and te...
Tue, 3 Apr, 2018 at 3:42 PM
How to run the motor position test on the Galaxi DVR 1644 lathe
This FAQ will show how to access and run the motor position test function on the NOVA Galaxi DVR lathe. The Motor position test will allow you to check ...
Thu, 19 Jul, 2018 at 4:04 PM
How to remove the control board
This FAQ will show how to remove the control circuit board from the NOVA DVR Galaxi woodlathe. 
Sun, 22 Jul, 2018 at 3:04 PM
How to remove the headstock on the DVR Galaxi 1644
This article is to show how to easily remove the headstock unit on the DVR Galaxi 1644 from its bed.  Headstocks may be removed for the following reason...
Sun, 22 Jul, 2018 at 3:15 PM
How to replace the control board on the DVR Galaxi 1644
This article shows how to remove and replace the control circuit board on the NOVA DVR Galaxi woodlathe.  The control circuit board may require replacem...
Sun, 22 Jul, 2018 at 3:39 PM
DVR Galaxi 1644 General Enquiries
This article answers several general questions that have often been asked about the NOVA DVR Galaxi woodlathe.  1. What is the dimension and weight of t...
Tue, 3 Apr, 2018 at 3:00 PM
How to replace the optic sensors on Galaxi 1644 lathe
This FAQ article shows how to replace the optic sensors on the NOVA Galaxi DVR woodlathe.  If the lathe continuously shows "RPS error" after c...
Sun, 22 Jul, 2018 at 3:58 PM
How to replace the Emergency Stop Button
This article shows how to take off the emergency stop button/switch (Big red button) in order to replace it on the NOVA Galaxi DVR woodlathe.
Tue, 24 Jul, 2018 at 3:48 PM
How to fix clicking noise and “Low Voltage” message on Galaxi DVR 1644 lathe
This FAQ article shows how to fix the clicking noise and "low voltage" message on the NOVA Galaxi DVR woodlathe. There are 2 solutions listed:...
Tue, 24 Jul, 2018 at 3:58 PM
How to convert the Galaxi DVR 1644 lathe to 220V input
This FAQ article shows how to convert the NOVA Galaxi DVR woodlathe to run on a 220V power supply. The Galaxi woodlathe is able to take in either 110V o...
Thu, 26 Jul, 2018 at 3:11 PM