DVR XP Lathe
Checking the serial number on the NOVA DVR XP can be done by entering the Service Mode of the DVR Software. Below is a step-by-step guide to entering the...
Tue, 17 Jul, 2018 at 3:03 PM
The Rotor Position Test is a very important way to check your DVR motor's condition. Before going into the Rotor position test, You need enter the Ser...
Tue, 18 Dec, 2018 at 4:45 PM
See attached PDF for instructions. The DVR XP mechanism is only 6 parts. If it is on a stand we will probably need to take it off to gain access. Here&#...
Wed, 27 Mar, 2019 at 1:57 PM
The RPS State Error relates directly to the sensor. If the first procedure of cleaning out the dust is unsuccessful then this procedure should be used. ...
Tue, 17 Jul, 2018 at 3:51 PM
These are the instructions on how to remove the control board from the NOVA DVR XP for replacement or repair.
Mon, 18 Jun, 2018 at 11:00 AM
This FAQ will provide solutions to fix the clicking noise made by the headstock and the "Low Voltage" warning which flashes on the LCD screen. ...
Thu, 19 Jul, 2018 at 2:43 PM
This FAQ article shows the parts and procedures required to change the voltage input from 110V to 220V on the NOVA DVR XP lathe.
Thu, 13 Jun, 2019 at 4:12 PM
This FAQ article shows how to re-tighten the tool-rest when it is not locking into place. Over time and/or heavy usage, the screws which secure the loc...
Thu, 19 Jul, 2018 at 3:27 PM
This FAQ article shows how to replace the keypad membrane on the NOVA DVR XP upgrade panel.
Thu, 19 Jul, 2018 at 3:47 PM
Please see the FAQ below for replacing the keypad on a Nova Saturn or XP Lathe
Thu, 28 Apr, 2022 at 6:07 PM