DVR 2024 Lathe
This FAQ details how to go about preforming a rotor position test on your NOVA DVR 2024 woodlathe.
Sun, 29 Jul, 2018 at 3:06 PM
This FAQ details how to enter the DVR Software's Service Mode and Check the parameters on NOVA DVR 2024 woodlathe.
Sun, 29 Jul, 2018 at 3:24 PM
Removing the Nova 2024 Headstock Reasons for removing headstock: 1. To replace the motor, spindle or bearings: 2. To replace detent pin: 3. To replace swive...
Mon, 28 Jan, 2019 at 2:31 PM
This FAQ is to clarify the compatibility between the NOVA DVR 2024 woodlathe and the NOVA DVR WIRELESS REMOTE II. The attached PDF only lists the compa...
Sun, 17 Jun, 2018 at 2:59 PM
This FAQ provides information on how to take the tailstock of the NOVA DVR 2024 woodlathe apart. The disassembly of the tailstock is needed for maintenance...
Sun, 29 Jul, 2018 at 3:47 PM
This FAQ article is about the potential cause of the "Low Voltage" error on the NOVA DVR 2024 woodlathe. The "Low Voltage" error is...
Sun, 29 Jul, 2018 at 4:13 PM