14th Dec 2016 


During a routine inspection, we have found that a small % of the new NOVA 1624 II Lathes have the motor reversed. We are supplying new stickers to show this configuration for the small number of customers who have this issue. 


If you are experiencing any issues, please stop using your NOVA 1624 II lathe and contact us. 


We will issue you with a new motor switch sticker to correct this problem. An outline of the corrective action can be found attached here, and is also listed on our website. 


If you are at all uncertain, please don't use your lathe and contact us to discuss.  


Its important to note this applies to a limited number of units, in a finite batch. All future batches do not have this issue and additional processes and checks have been put in place to ensure this does not happen again. 


We apologize for any inconvenience caused.


The NOVA Team