Teknatool International

The attached FAQ document will show how to get into service mode on the Galaxi DVR 1644 lathe.  Service mode will allow access to more parameters and te...

This FAQ will show how to access and run the motor position test function on the NOVA Galaxi DVR lathe. The Motor position test will allow you to check ...

This FAQ will show how to remove the control circuit board from the NOVA DVR Galaxi woodlathe. 

This article is to show how to easily remove the headstock unit on the DVR Galaxi 1644 from its bed.  Headstocks may be removed for the following reason...

This article shows how to remove and replace the control circuit board on the NOVA DVR Galaxi woodlathe.  The control circuit board may require replacem...

This article answers several general questions that have often been asked about the NOVA DVR Galaxi woodlathe.  1. What is the dimension and weight of t...

This FAQ article shows how to replace the optic sensors on the NOVA Galaxi DVR woodlathe.  If the lathe continuously shows "RPS error" after c...

This article shows how to take off the emergency stop button/switch (Big red button) in order to replace it on the NOVA Galaxi DVR woodlathe.

This FAQ article shows how to fix the clicking noise and "low voltage" message on the NOVA Galaxi DVR woodlathe. There are 2 solutions listed:...

This FAQ article shows how to convert the NOVA Galaxi DVR woodlathe to run on a 220V power supply. The Galaxi woodlathe is able to take in either 110V o...