Updated DVR FAQs

How to fix the Hardware Fault at low RPM for DVR Saturn DVR Orion and DVR Voyager
If your machine stops spinning and displays a ‘Hardware Fault’ warning while roughing up wood at or lower than 500 rotations-per-minute (RPM), then you may ...
Sun, 13 Dec, 2020 at 5:02 PM
How to upgrade HMI firmware for DVR using NOVA firmware uploader or ST-Link
One of the advantages of the DVR smart motor is the ability to upgrade the Human Machine Interface (HMI) software via USB. Upgrading to the latest firmware ...
Thu, 14 Jan, 2021 at 6:19 PM
How to Align Tailstock with Spindle for DVR Lathes
Generally new lathe tailstocks are inspected in-factory and does not need to be aligned again. Over time, the lathe tailstock may need to be re-aligned as s...
Thu, 14 Jan, 2021 at 10:00 PM
How to Check for Runout on NOVA Lathes and Drill Presses
You may be experiencing run-out if any part of the lathe or drill press wobbles or vibrates while spinning.  This is usually caused by parts of the lath...
Thu, 14 Jan, 2021 at 10:03 PM
How to Enter Service Mode on NOVA DVR 2024
On your DVR 2024, Service mode will give you access to your lathe parameters and the Rotor Positioning Test (RPS Test).  To access service mode on an origi...
Thu, 14 Jan, 2021 at 10:17 PM
How to Replace the Main Control Board and HMI Panel for DVR 3000
If you are installing a DVR Upgrade kit Main Control Board (MCB) or removing the MCB for maintenance download the FAQ guide below for step-by-step instructi...
Thu, 14 Jan, 2021 at 10:34 PM
How to Replace the Main Control Board and HMI Panel on a DVR 3000
If you need to: - Install a new control board - Remove control boards for servicing Follow the guide attached below for a step by step guide to get th...
Tue, 19 Jan, 2021 at 6:37 PM
RPS state and Run low RPM errors on a DVR 3000
The RPS or Rotor Positioning Sensor error may manifest if there is no or bad feedback from the internal optical sensors in the DVR headstock. Run low RP...
Tue, 19 Jan, 2021 at 6:49 PM
How to enter Service mode on NOVA DVR 3000
On your DVR 3000, Service mode will give you access to your lathe parameters and the Rotor Positioning Test (RPS Test).  To access service mode on an origi...
Tue, 19 Jan, 2021 at 6:51 PM
How to Configure the Vibration Sensor on the DVR Saturn or Upgraded DVR 3000
The vibration sensor will automatically shut down the lathe if it detects unsafe working conditions via an on-board accelerometer constantly monitoring the ...
Tue, 19 Jan, 2021 at 6:53 PM