General DVR Machine FAQs
Typically an RPS Error is an issue involving a wiring connection, dust obstructing the optic sensors, or a faulty sensor. After clearing the obstruction...
Fri, 17 May, 2019 at 3:12 PM
Typically Fault/Error/No Voltage/Low Voltage is a wiring connection.. Check the power receptacle first. Then unplug the power and remove the four sc...
Mon, 22 Apr, 2019 at 11:06 AM
DVR XP/2024 INDEX MECHANISM LOOSE/RATTLING NOISE IN HEADSTOCK
Remove the handwheel, if you are using it. It is left hand threaded so turn clockwise...
Thu, 8 Mar, 2018 at 1:10 PM
There are two things you need to look for when facing the problem of a Tailstock Quill which will not slide back into the tailstock of your NOVA 1624-44, NO...
Tue, 3 Jul, 2018 at 3:08 PM
To check your DVR product's compatibility with the 55523 upgrade panel, visit the following FAQ: https://teknatool.freshdesk.com/solution/artic...
Thu, 29 Aug, 2019 at 8:58 AM
Black left, white right. Here are the two most common configurations. The board near the black connection is marked 'L" Live. The white is marke...
Tue, 13 Mar, 2018 at 1:44 PM
Newer DVR machines (~2010 and on) are pre-wired for 220V, and the electronics inside are able to detect and accommodate the change in voltage supply. To acc...
Tue, 28 May, 2019 at 9:14 AM
Reasons for removing headstock: 1. To replace the motor, spindle or bearings: 2. To replace detent pin: 3. To replace swivel lock pin Be advised the heads...
Wed, 8 Mar, 2017 at 4:37 PM
This FAQ article introduces how to take off and install the handwheel and faceplate on the DVR lathes. The DVR series lathes from NOVA (Galaxi, XP, 202...
Tue, 21 Mar, 2017 at 9:23 PM
Q: What does "LOW" mean? A: Low is shown on the display when the position sensor reads a speed below 25RPM (Usually 0RPM). This message usually ...
Thu, 21 Jun, 2018 at 11:07 AM